Now let’s share a tutorial about a handsome man’s own haircut. This is a long hair style without connecting the structure, that is, the back neck of the temples is not connected with the top hair, forming two regions, which is also a common cutting method in barber shops.
Step 1: Preparation
Prepare tools for haircut: electric pusher, caliper, comb, clip, razor, hair dryer.
First, use the clip to clip the hair on the top of your head. The position is to go back from the forehead by an arc. This is the position of the top area. Then, first install a thick caliper on the electric pusher, and first push the long hair short.
Step 2: gradually shorten the sideburns and back neck
Use a large caliper to shorten the longer part; Replace the caliper with a smaller one and gradually shorten it. Don’t worry. This process is very critical. Boys have short hair and sideburns hair from short to long. To form a gradual transition, you must first follow the principle of thick then thin.
Step 3: Connection and transition
According to the prompts in the figure, select different calipers at the three parts, the thinnest calipers at the bottom, and so on. Push it at the bottom, replace it with a larger caliper, and push it repeatedly at the connecting part. Be careful not to push it too fast, and eliminate the trace of connection bit by bit.
Step 4: Bottom line gradient processing
This step is very important. Remove the caliper, adjust the tooth pitch of the pusher to the minimum, and handle the hair on the hairline first. Push bit by bit. The bottom push is stuck on the scalp, and the angle is gradually adjusted when it reaches the connecting position.
You can also make a mark at the connecting position with a pusher, and then push the hair below it, and then make a gradual transition from the position of the titling line.
Step 5: Intermediate gradient processing
For hair in the middle, slightly increase the tooth pitch, so that even if it is close to the scalp, the hair will not be pushed away, which means that a certain thickness will be retained.
The key point is that the connection and transition from short to long should not be hurried. The angle of the pusher should be controlled by hand to make the transition upward.
Step 6: Bottom line scraping
After the gradient effect is pushed, the bottom line needs to be handled.Shave the bobbin thread with a razor to form a green removing effect. Pay attention to the transition. It should not be too stiff.
Step 7: Top area clipping
Put all the top hair down, and then set the length from the bangs.
Separate the hair from the top of the head, from front to back, from left to right, that is, draw a cross on the top of the head and fix it with a clip. Then cut the bangs, first determine the length, then lift them to the position 90 degrees from the scalp, and use scissors to cut off the excess hair.
By analogy, we only need to master the left and right symmetry. This step is difficult to master, because looking at your fingers in the mirror is reverse, and you need to practice repeatedly to cut your hair.
Step 8: Cropping the top and back areas
After the hair at the fringe position is cut short, use the same method to cut the hair at the top and back area with reference to the length of the fringe. The method is the same as above.
Then comb the hair to the natural position, and cut the hair in the side area neatly.
Step 9: Apply styling products
After cutting the length of the hair in the side area, wash the stubble off the hair and blow it dry.
Mousse, hair wax and gel water can be used for modeling products. Smear the styling products on the hair and sort out the desired styling.
Step 10: End of modeling
The style of hair style varies from person to person. The style you like is the way you like. The hair spray at the left rear will fix the hair style.
This hairstyle is more difficult than the round inch hairstyle and the three side light hairstyle, but if you look carefully at the tutorial, you will find that the difficulty is mainly the connection and cutting of the top hair, as well as the inability to see the back part of the brain, all depending on the feeling, which requires repeated exploration and practice to get a natural effect.
